Skip to main content
012 541 3596

Warrior Quick Drying (QD) Enamels

Warrior Quick Drying Enamel

Back to Warrior Industrial Paints

Warrior Quick Drying Enamel is a styrenated alkyd based industrial spraying enamel, which dries to a gloss finish.

USES :

Warrior Quick Drying Enamels can be used as a finishing coat on suitably primed metal substrates. It is suitable for interior or exterior use.

SPECIFICATION OR RECOMMENDED PAINT SYSTEM :

Steel surfaces : Apply one coat of Warrior QD Red Oxide Primer to cleaned steel and allow to dry for 4 hours. Thereafter finish off with 2 coats of Warrior QD Enamel allowing 4 hours drying time between coats.

PROPERTIES :

APPLICATION: Conventional Spray

CLEANING SOLVENT: E-Thinners

THINNING SOLVENT: E-Thinners

SPREADING RATE:

  • PRIMER COAT : N/A
  • FINAL COAT : 8 m² per litre

DRYING TIMES:

  • SURFACE DRY : 30 minutes
  • HARD DRY: 3-4 hours
  • OVERCOATING : 4 hours

PACK SIZE: 1L, 5L, 25L

COLOUR RANGE: White, black and a range of standard colours

SPECIFIC GRAVITY: 1,00 + 0,05 kg per litre

VISCOSITY: 80-100 seconds F4

FLASH POINT: 9°C

FINISH: Gloss

GENERAL INFORMATION :

  • This product must not be applied over White Spirits/Alkyd base paints.
  • This product is recommended for spray application. Due to its quick drying nature only small areas may be brushed.

c) It is impor­tant that this product be thoroughly mixed with a flat paddle before use.

Contact us for the Warrior Quick Drying Enamel.

Leave a Reply