Warrior Econofill PVA
Warrior Econofill P.V.A.
Back to Warrior Water based Primers and Fillercoats
Warrior Econofill is a low cost P.V.A. formulated mainly for the contracting market. It has good all round properties ie. obliteration, filling, drying and overcoating.
Warrior Econofill P.V.A. can be used as a first coat on raw plaster and a final coat on ceilings. It may be used mainly where an economic, uniform finish is required.
SPECIFICATION OR RECOMMENDED PAINT SYSTEM :
Ensure all surfaces to be painted are clean, free from dust, dirt and grease. Apply one or two coats Warrior Econofill as required. The paints which may be applied over Warrior Econofill are Warrior General Purpose P.V.A or Warrior Super Acrylic P.V.A. Allow 4 hours drying time before overcoating.
PROPERTIES :
APPLICATION: Brush or Roller
CLEANING SOLVENT: Water
THINNING SOLVENT: Water
SPREADING RATE:
- PRIMER COAT : Depending on porosity of plaster 4-6 m² per litre
- FINAL COAT : 6-8 m² per litre
DRYING TIMES:
- SURFACE DRY : 1 hour
- HARD DRY : 4 hours
- OVERCOATING : 4 hours
PACK SIZE: 5L, 20L (200L on request)
COLOUR RANGE: White only
SPECIFIC GRAVITY: 1,4 + 0,05 kg per litre
VISCOSITY: 100-120 KU
FLASH POINT: Non Flammable
FINISH: Matt
GENERAL INFORMATION :
a) If this product is used as a finishing coat on ceilings all bare metal areas (e.g. nail heads etc.) must be primed with a metal primer.
b) For this product the wet obliterating properties may not be as good as the dry obliterating properties.
c) It is important that this product be thoroughly mixed with a flat paddle before use.
Contact us for the Warrior Econofill P.V.A.