Warrior Metal Etch Primer
Warrior Metal Etch Primer
Back to Warrior Water based Primers and Fillercoats
Warrior Anti-Corrosive Metal Etch Primer is a non-toxic dual purpose acrylic coating. It has excellent etching and quick drying properties.
USES :
Warrior Anti-Corrosive Metal Etch primer can be applied as a primer coat to ferrous metals, cast iron, galvanised and aluminium products.
SPECIFICATION OR RECOMMENDED PAINT SYSTEM :
The surface should be clean and free from rust, dirt, grease, dust and oil. Stir Warrior Anti-Corrosive Metal Etch Primer thoroughly with a flat paddle before use. Apply one coat of the Warrior Anti-Corrosive Metal Etch Primer and allow it to dry for 4-6 hours before re-coating.
PROPERTIES :
APPLICATION: Brush, Roller or Spray*
CLEANING: Water
THINNING SOLVENT: Water
SPREADING RATE:
- PRIMER COAT : + 7-8 m² per litre
- FINAL COAT : N/A
DRYING TIME:
- SURFACE DRY : 1 hour
- HARD DRY : 4 hours
- OVERCOATING : 4-6 hours
PACK SIZE: 250ml, 1L, 5L, 20L (200L on request)
COLOUR RANGE: Red Oxide and Black
RELATIVE DENSITY: 1,25 +0,05 kg per litre
VISCOSITY: 70-75 KU
PH: 4-6
F.O.G. <30 F m
NV: 55-60%
VOL. SOLIDS: +36%
DFT: 30-35microns
GENERAL INFORMATION :
*For spray application consult our Technical Department.
a) Certain solvent based paints may have a detrimental effect on this product. A test patch should be carried out to determine whether the product is compatible with the solvent based paint in question before re-coating the entire surface.
b) It is important that this product be thoroughly mixed with a flat paddle before use.
Contact us for Warrior Anti-Corrosive Metal Etch Primer