Warrior Alkali Resistant Bonding Liquid
Warrior Alkali Resistant Bonding Liquid
Back to Warrior Acrylic Primers and Sealers
Warrior Alkali Resistant Bonding Liquid is a synthetic resin based clear sealer for porous and powdery surfaces. It has excellent alkali resistance, binding and penetrating properties, and dries quickly to a well bonded substrate for subsequent primers and top coats.
USES :
Warrior Alkali Resistant Bonding Liquid is an excellent sealer to be used on:
- Distempered surfaces
- Raw plaster walls
- Brickwork, ceilings and cement renderings.
SPECIFICATION OR RECOMMENDED PAINT SYSTEM :
Surface Preparation for old/previously painted masonry surfaces: Multiple layers of previous paint layers in a poor condition must be stripped back to a firm base or the original surface. All lime wash/distemper surfaces must be scraped off and brushed down to a firm base. All surfaces must be clean, dry and free of any dirt and surface contamination before any application of paint.
PROPERTIES :
APPLICATION: Brush*, Roller, Spray
CLEANING SOLVENT: Mineral Turpentine
THINNING SOLVENT: Mineral Turpentine
SPREADING RATE:
- PRIMER COAT : 8-10m² per litre (depending on surface porosity)
- FINAL COAT : N/A
DRYING TIMES:
- SURFACE DRY : 1 hour
- HARD DRY: 4-6 hours
- OVERCOATING :24-72 hours
PACK SIZE: 1L, 5L, 20L
COLOUR RANGE: Clear only
SPECIFIC GRAVITY: 0,9 + 0,05 kg per litre
VISCOSITY: 15-20 “F4 cup
FLASH POINT: >35°C
FINISH: Sheen
GENERAL INFORMATION :
*Brush application is preferred as this ensures penetration into the substrate.
- This is a low viscosity bonding liquid and is supplied ready for use.
- Can be over coated with most conventional decorative solvent and emulsion finishes.
c) Warrior Alkali Resistant Bonding Liquid must be overcoated within 72 hours. Failure to do so will result in poor adhesion of the topcoat.
d) It is important that this product be thoroughly mixed with a flat paddle before use.
Contact us for the Warrior Alkali Resistant Bonding Liquid.