Warrior Alkali Resistant Plaster Primer
Warrior Alkali Resistant Plaster Primer is a synthetic resin based white pigmented primer/sealer which is formulated to resist the effects of alkalinity on subsequent coats of paint. It has good penetrating properties and dries to a hard matt finish.
Warrior Alkali Resistant Plaster Primer is recommended for use on any brick, plaster, concrete and fibre-cement surfaces. It is also recommended for use on masonry rhinolite surfaces.
SPECIFICATION OR RECOMMENDED PAINT SYSTEM :
- Surface preparation and application : Essential for good paint performance is a sound substrate that has been properly prepared and cleaned. The standard conditions for the preparation of plastered/masonry surfaces apply. Warrior Alkali Resistant Plaster Primer can be either thinned or used as is, depending on the porosity of the surface.
- Surface preparation for old/previously painted masonry surfaces: Multiple layers of previous painted layers in poor condition must be stripped back to a firm base or the original surface. All lime wash/distemper surfaces must be scraped off and brushed down to a firm base. All surfaces must be clean, dry and free of dirt and surface contamination before any application of paint.
APPLICATION: Brush, Roller or Spray*
CLEANING SOLVENT: Mineral Turpentine
THINNING SOLVENT: Mineral Turpentine
- PRIMER COAT : 6-8m² per litre (depending on surface porosity)
- FINAL COAT : N/A
- SURFACE DRY : 1-2 hours
- HARD DRY : 4 hours
- OVERCOATING : 4 hours
PACK SIZE: 250ml, 1L, 5L, 20L, 20L
COLOUR RANGE: White only
SPECIFIC GRAVITY: 1,20 + 0,05 kg per litre
VISCOSITY: 75-80 KU
FLASH POINT: >35° C
NON VOLATILE (%) 50-55%
GENERAL INFORMATION :
*For spray application contact our Technical Department.
It is important that this product be thoroughly mixed with a flat paddle before use.
Contact us for the Warrior Alkali Resistant Plaster Primer.