Warriorshield™ Kwik ’n Eezi Waterproofing
Back to Waterbased Sealers
Warriorshield™ Kwik ’n Eezi Waterproofing is a highly durable heavy bodied fibre reinforced water based acrylic waterproofing liquid/sealer.
Warriorshield™ Kwik ’n Eezi Waterproofing can be used to seal or waterproof and strengthen porous surfaces e.g. Fibre cement roof sheets, concrete roof tiles and parapet walls etc. It can also be used to bridge and seal hair line cracks on walls which are to be sealed or waterproofed.
SPECIFICATION OR RECOMMENDED PAINT SYSTEM :
The areas to be sealed or waterproofed must be dry, free of any dirt, dust loose particles and other surface contaminants. Surface preparation and application can vary depending on the nature, size and shape of the substrate/job.
For large jobs or when in doubt consult our Technical Service Advisor.
Recommended Application Process:
- Prime areas to be sealed or waterproofed with Warriorshield™ Saturator and allow to dry (+0,25 litre per m²)
- Apply 2 coats of Warriorshield™ Kwik ’n Eezi Waterproofing with a roller or block brush at a spreading rate of approximately 1 litre per m² allowing 3-4 hours drying time in between coats.
APPLICATION: Block brush or Roller
CLEANING SOLVENT: Water
THINNING SOLVENT: Water
SPREADING RATE :
- PRIMER COAT : N/A
- FINAL COAT : 1 litre per m²
- SURFACE DRY : 1 hour
- HARD DRY : 4 hours
- OVERCOATING : 4 hours @ +23ºC
PACK SIZE: 1L, 5L, 20L
COLOUR RANGE: Red Oxide, White and Grey
FLASH POINT: Non Flammable
FINISH: Low sheen
GENERAL INFORMATION :
a) This product is not recommended for use on the inside of dams and swimming pools or in ponding situations. This material is supplied ready for use and should not be thinned.
b) For metal roofs and nail heads, prime as per our specification for Warrior Metal Etch Primer and coat as recommended above.
c) It is important that this product be thoroughly mixed with a flat paddle before use.
Contact us for the Warriorshield™ Kwik n Eezi Waterproofing.