Warriorshield™ Saturator

Back to Warrior Water based Primers and Fillercoats

Warriorshield™ Saturator is an acrylic waterproofing liquid primer/sealer. It’s low solids, good penetrating and saturating properties together with its good adhesion to substrates makes it the ideal primer/sealer to be used as part of the Warriorshield Waterproofing system.

USES :

Warriorshield™ Saturator has been formulated to be used as part of the Warriorshield 5-coat Waterproofing System, as the primer and saturator coats.

SPECIFICATION OR RECOMMENDED PAINT SYSTEM :

1. SURFACE PREPARATION:

The area to be waterproofed must be dry, free of any dirt, dust, loose particles, and other contaminants. Surface preparation and application can vary depending on the nature, size and shape of the substrate/job. For large jobs or when in doubt consult our Technical Service Advisor.

2. RECOMMENDED APPLICATION PROCESS:

a) Apply liberally to substrate by brush or roller one coat of Warriorshield™ Saturator and allow to dry. (0.25 to 0.5 litre per m²)

b) Apply by brush or roller one liberal coat of Warriorshield™ Waterproofing liquid as supplied and fix fabric or waterproofing membrane using a roller while the paint is still wet. Allow to dry. (1.0 to 1.5 litre per m²)

c) Apply a third coat of Warriorshield™ Saturator to ensure that the fabric is completely saturated.(0.25 to 0.5 litre per m²)

d) Finish with two coats of Warriorshield™ Waterproofing liquid to desired colour. (0.5 litre per m² per coat). A spreading rate of 2.5 to 3.0 l Warriorshield™ Waterproofing Liquid per square meter of reinforcing fabric is recommended. Each coat must be thoroughly dry before over coating.

PROPERTIES :

APPLICATION: Brush, Roller or Spray

CLEANING SOLVENT: Water

THINNING SOLVENT: Water

SPREADING RATE:

• PRIMER COAT : 0,25-0,05 litre per m²
• FINAL COAT : N/A

DRYING TIMES:

• SURFACE DRY : 1 hour
• HARD DRY : 3-4 hours

PACK SIZE: 5L, 20L (200L on request)

COLOUR RANGE: Red Oxide only

SPECIFIC GRAVITY: +1,3 + 0,05 kg per litre

VISCOSITY: 100-110 KU

FLASH POINT: Non Flammable

GENERAL INFORMATION :

• This product is supplied ready for use and should not be thinned.
• It is impor­tant that this product be thoroughly mixed with a flat paddle before use.

Contact us for the Warriorshield™ Saturator.