Warrior One Pack Etch Primer
Warrior One Pack Etch Primer
Back to Warrior Solvent Based Industrial Primers
Warrior One Pack Etch Primer is a PVB/Phenolic resin based anti-corrosive primer. This primer has very good etching properties, is quick drying with fast re-coating properties and has excellent adhesion to a range of metals.
USES :
Warrior One Pack Etch Primer is an ideal pre-treatment or anti-corrosive primer for new steel surfaces, which have been sand blasted to ISO SA 2½ min., and galvanised steel.
This primer provides an excellent base for subsequent re-coating with other conventional primers and top coats e.g. alkyd enamels or quick drying enamels.
SPECIFICATION OR RECOMMENDED PAINT SYSTEM :
SURFACE PREPARATION :
a) Steel: Surface must be clean and dry before priming. All mill scale and rust must be removed by mechanical abrasion, or sand blasting
b) Galvanised Iron: New Galvanised Iron Surfaces should be cleaned with Warrior Galvanised Iron Cleaner.
FINISHING :
a) Apply one coat of Warrior OPEP to the clean metal surface. Allow to dry for 4 hours before overcoating with the Warrior top coat of choice.
PROPERTIES :
APPLICATION: Spray or Dipping (Brush small areas)
CLEANING SOLVENT: OPEP Thinners*
THINNING SOLVENT: OPEP Thinners
SPREADING RATE:
- PRIMER COAT : 8-10 m² per litre
- FINAL COAT : N/A
DRYING TIMES:
- SURFACE DRY : 30 minutes
- HARD DRY : 2-4 hours
- OVERCOATING : 4 hours
PACK SIZE: 1L, 5L, 25L (200L on request)
COLOUR RANGE: Black, Red Oxide
SPECIFIC GRAVITY: 0,90 kg per litre
VISCOSITY: 100-120 seconds F4
FLASH POINT: 12°C
FINISH: Matt
RECOMMENDED DRY FILM THICKNESS: 20-25 microns
GENERAL INFORMATION :
*Contact our Technical Department for the correct thinning ratios.
- This product is recommended to be applied in a well ventilated area. If used in confined spaces/areas the necessary safety precautions for hazardous solvent inhalation must be adhered to.
- It is important that this product be thoroughly mixed with a flat paddle before use.
Contact us for the Warrior one pack etch primer.